Pool Enclosures

1.  Your pool enclosure install is going to be a snap.

2. Let's get started on your pool enclosure installation.

3. Drill holes every 24” apart around pool as marked.

4. Use a 1/2” masonry bit.

5. Drill into concrete decking.

6. Holes need to be 1½” deep into concrete deck.

7. Use 1/2” anchor.

8. Insert anchor into deck, must be flush or below surface.

9. Take setting tool, place tapered end into anchor.

10. Using a sledge hammer lightly tap the setting tool one to two times to lock anchor into concrete.

11. Insert eye bolt into anchor.

12. Tighten eyebolt face open end away from pool.

13. Continue around your in ground pool.

14. Good, the hard part is done.

15. Start to unfold the pool enclosure.

16. Make sure the pool enclosure is unfolding as per drawing we sent you.

18. Continue to pull and unfold.

19. Position the enclosure over the pool.

21. Make sure doors are located as shown in drawing.

22. Cut a 1” to 1½” slice into pocket.

23. Expose cable in pocket.

24. Hook cable over eyebolt.

25. Continue around the pool pulling slack out between eyebolts as you go.

26. This is how the eyebolts will look after pool enclosure is inflated.

27. Remove blower from box.

28. Position blower in a convenient location.

29. Insert blower under the enclosure skirting.

30. Find the switch on the blower.

31. Turn blower on high until the dome is completely inflated.

32. Lower the blower setting to lower setting.

33. Blower set on high.

34. Blower set low.

35. Come on in and check out your new pool enclosure!

36. Fit blower to pool enclosure skirt.

37. Cut pool enclosure skirt so it will lay flat.

38. Now you have a tight fit.

39. Inside skirt should lay flat.

40. Cut corners so the skirt flap lays flat.

41. Don’t try this at home!

42. Congratulations, your pool enclosure is ready to enjoy.

43. In the Summer time, don't forget to remove the eyebolts.

44. Insert a stainless steel plug when the dome is removed. This is done so debris will not get into the hole.